Projects

We have removed the old plasterboard and have superfoiled. Once you check that the superfoil is done correctly we will proceed with adding batons and plaster and proceed skimming.

Sf19+ under rafter insulation Membrane lap vents fitted 50m2 minimum charge 75mm mineral wool installation

Apply Anti-Fungal treatment to the loft area. Supply and install Multi-Foil to approximately 50m² of loft area. Loft measurement from floor joist to ridge is approximately 2m. Ensure the Multi-Foil is properly fitted and secured throughout the designated loft area. Leave the loft area clean and tidy upon completion.

Superfoil Install Remove fibreglass Wood Treatment remove items from loft and put them back up after we have installed the superfoil

Loft 1 (with timber ladders – better access in hallway) a) Existing floorboards are to be lifted so we can remove the fibreglass underneath. The original floor will then be relaid on raised timbers so the 100mm Knauf underneath can breathe. (Please be aware that we will not refit any damaged/damp flooring.) If we do […]

There are 2 lofts in this property, as this was originally 2 houses. Loft 1 (with timber ladders – better access in hallway) a) Existing floorboards are to be lifted so we can remove the fibreglass underneath. The original floor will then be relaid on raised timbers so the 100mm Knauf underneath can breathe. (Please […]

Remove remnants of foam from the eaves. Supply and install MultiFoil 60m² to the agreed areas. Carry out the works over an estimated 1–2 days. Existing loft is empty with no loft flooring or boarding. General roof condition is OK. Damp was found, with a damp reading of 13. Remove all waste generated during the […]

Supply and install 87m² of SF19 SuperFOIL insulation across 4 sides and 2 lofts. Carry out minor centralisation of items within the loft/attic area where required. Fit insulation neatly around existing timbers, lights, flooring, boarding, pipework, and other obstructions. Maintain suitable ventilation to minimise condensation and moisture build-up. Complete final checks and leave the work […]

Remove all old fibreglass and debris. Remove old water tanks. Install boards to rafters thru the centre of the loft. Fit SF19+ to sloping ceilings down the eaves. Install lap vents to insure adequate ventilation to roof structure. Install 48 sqm of SF19+ throughout. Tape and seal to wall plate. Redirect bathroom extraction fan thru […]

SUPERFOIL RETRO FIT